Page 1 of 3
[ADDED] Thumbnails in GCODE
Posted: Tue Dec 20, 2022 4:26 am
by Crenwick
Hi there,
I just upgraded to V5.0 and it's working really nice
I'm using Klipper/Mainsail and it should really be nice to see the thumbnails in the monitor.
Could you please add this feature in the next version ?
Regards,
Bernard
Re: Thumbnails in GCODE
Posted: Tue Dec 20, 2022 6:17 pm
by S3D-Jason
Great suggestion! Do you know what resolution thumbnails you would want?
Re: Thumbnails in GCODE
Posted: Wed Dec 21, 2022 4:21 am
by arhi
S3D-Jason wrote: ↑Tue Dec 20, 2022 6:17 pm
Great suggestion! Do you know what resolution thumbnails you would want?
Cura generates 300x300px thumbnails
Prusa Slicer by default generates 16x16px and 200x200px but it is configurable
between 200x200 and 300x300 would be great, following same format as Prusa Slicer might be best
Re: Thumbnails in GCODE
Posted: Wed Dec 21, 2022 11:57 pm
by billyd
S3D-Jason wrote: ↑Tue Dec 20, 2022 6:17 pm
Great suggestion! Do you know what resolution thumbnails you would want?
32x32 for small and 400x300 for big is typical for mainsail
Re: Thumbnails in GCODE
Posted: Thu Dec 22, 2022 1:27 am
by wuast94
should be configurable
Re: Thumbnails in GCODE
Posted: Fri Dec 23, 2022 9:02 am
by Crenwick
S3D-Jason wrote: ↑Tue Dec 20, 2022 6:17 pm
Great suggestion! Do you know what resolution thumbnails you would want?
Hi !
Well, like already described by others, configurable is the best but for Mainsail 32x32 for small and 400x300 for big is recommended
Regards
Bernard
Re: Thumbnails in GCODE
Posted: Mon Dec 26, 2022 10:44 pm
by gavitron
+1 (or, however we are meant to indicate we would also like this functionality added).
Re: Thumbnails in GCODE
Posted: Sat Dec 31, 2022 5:21 am
by JeffwearLLC
+1
Re: Thumbnails in GCODE
Posted: Tue Jan 03, 2023 9:49 am
by blitzkneisser
Looking forward to that feature!
Re: Thumbnails in GCODE
Posted: Wed Jan 04, 2023 11:41 am
by cfi700
+1