Simplify3D User Forum

Don't know if it makes any difference, but my machine is a MakerGear M2. Here are the annoyances I have seen so far:
- E-Stop button doesn't work.
- Disable Motors button doesn't work.
- No Speed/Feed overrides.
- Value input boxes up/down arrows don't repeat with long press.
- No running estimate of time remaining or % done for currently running print.
- No notification of total execution time when print finishes.
- No live line tracking.
- No macro buttons.
- On the Accessory Controls tab, the Heated Bed light never comes on.

Version 5.0.0 on Mac Monterey with a Robo3D R1+ I see these same issues you listed:

- E-Stop button doesn't work.
- No running estimate of time remaining or % done for currently running print.
- No notification of total execution time when print finishes.
- No live line tracking.
- On the Accessory Controls tab, the Heated Bed light never comes on.

We are making an improvement to the E-stop button for our upcoming 5.0.1 release, which I think will do a better job of stopping execution on a wider variety of machines. So hopefully that one will be fixed shortly.

For the Disable Motors button, have you used V4 previously? Do you know if the same Disable Motors button worked in V4 successfully? Just curious to know if this was something that was already working before V4 or not.

For the heated bed light, it might help to know what printer you are using. I just ran a test myself and the light seemed to be working correctly, but obviously this may be handled differently for each printer.