I think that might be a different issue. I think the original post was about the time display in S3D, not on the printer itself.
I will check that. The printers I have noticed this on so far do ok with time using V4. Just as an FYI.S3D-Jason wrote: ↑Wed Jan 04, 2023 9:00 am
Some printers try to parse the print time from the gcode file comments, so if the machine isn't showing the time, you may want to check the bottom of the gcode file to make sure the time is listed there (it should be the last 5 or so comment lines in the file)