Dear Simplify3D Team,
can you please add a profile for the V400 to S3D 5.0? There is a lot of good coverage of their devices already.
FLSUN Cube
FLSUN i3
FLSUN i3 Plus
FLSUN Kossel Delta
FLSUN Q5 Delta
FLSUN QQ Delta
FLSUN Super Racer
The V400 is sold and shipped by now.
Vendor URL: https://flsun3d.com/products/flsun-v400
Thank you very much!
Best regards,
Florian
Re: Profile for FLSUN V400
Does anybody have a profile for this yet??
Re: Profile for FLSUN V400
This was already added to the software in Version 5.0.1. Go to Help > Configuration Assistant, type "V400" and you will see it.
We've been using it on our V400 quite a bit over the past month. The default print speeds are somewhat conservative, so once it's printing well you can certainly begin speeding it up.
We've been using it on our V400 quite a bit over the past month. The default print speeds are somewhat conservative, so once it's printing well you can certainly begin speeding it up.
