Simplify3D User Forum

Posted: **Thu Jan 05, 2023 10:49 am**

First layer setting Bug when switching from Percentage to Absolute and vice versa. (See Attached)

Posted: **Tue Jan 10, 2023 9:44 am**

The settings are independent. For example, you might want a percentage of 150%, or you may prefer a fixed first layer height of 0.2mm. You can set each of those independently depending on which mode you want to use.

Simplify3D User Forum

First layer setting Bug when switching from Percentage to Absolute and vice versa.

First layer setting Bug when switching from Percentage to Absolute and vice versa.

Re: First layer setting Bug when switching from Percentage to Absolute and vice versa.