V4 and V5 are both on my Linux machine. Both installed no problems. Used V4 for at least 4-5 years now.
After installing V5, the bottom layer isn't putting the filament on the bed. The extruder makes occasional clicking noises, so I'm assuming there's some odd setting causing this.
I printed an STL file on both software versions TWICE. V4 is flawless. But V5 keeps repeating it's problem.
I get a snot wipe on V5, and it STARTS to lay down some filament, but it just ...stops giving filament. And then the occasional clicking begins from the extruder.
Printer is a CR-10 Mini. Printer profile was selected to match in V5. Imported settings from V4. Painstakingly verified settings between the two software versions.
I cannot pin down what's changed. There HAS to be some setting in V5 that is causing the extruder problem.
Anyone encountered this?