Simplify v 5.0.1 crashes intermittently on me when I have a factory file open and try to open a different factory file.
The factory files were created prior to updating to V 5.
OS: Win 11
I followed your sequence and I can confirm that it doesn't crash if the factory file is saved after I slice the model.billyd wrote: ↑Tue Jan 24, 2023 11:13 am I get crashes sometimes if I save a factory file and then slice the model. It doesn't seem to crash if I slice first and then save the factory file. But it could also just be random haven't been able to nail down the exact cause frankly. The good news is I am getting less crashes than with 5.0
Hello, my 'crash problem' is that v 5.0.1 crashes 100% upon opening. I start the program, the program opens, 2 seconds later it closes...every time. I had to uninstall v5 totally and re-install (and not update to 5.0.1 for it to work). Should I start my own issue thread about this or is there another route to follow?S3D-Jason wrote: ↑Mon Jan 30, 2023 9:51 am I have tried following a lot of these steps, but still haven't been able to reproduce any crashes on my end. Does anyone have a more consistent set of instructions they can share to reproduce the problem? Can you confirm what operating system you are using?
My current OS is Win 10 Pro.S3D-Jason wrote: ↑Mon Jan 30, 2023 9:51 am I have tried following a lot of these steps, but still haven't been able to reproduce any crashes on my end. Does anyone have a more consistent set of instructions they can share to reproduce the problem? Can you confirm what operating system you are using?
It happens pretty much everytime I go through those steps. I'll try to create a template from scratch in the current version and see if the issue persists.S3D-Jason wrote: ↑Wed Feb 01, 2023 10:34 am I followed these exact steps several times, but I can't seem to get the crash to happen using the same OS. Does it happen repeatably for you, or does it sometimes work correctly? Do you think it is related to a specific model or process setting you are using?
Would be curious to see if any other users can reproduce this, since we haven't had any luck so far.
I get random crashes too on MacOS Ventura when saving the factory and then trying to slice.billyd wrote: ↑Tue Jan 24, 2023 11:13 am I get crashes sometimes if I save a factory file and then slice the model. It doesn't seem to crash if I slice first and then save the factory file. But it could also just be random haven't been able to nail down the exact cause frankly. The good news is I am getting less crashes than with 5.0