kkinney
Posts: 1
Joined: Wed Jan 25, 2023 9:38 pm

CR-10 Z+ & Z- both move downward

CR-10 Z+ & Z- both move downward

On top of that, while the Z axis is moving, I hit the limit switch and nothing happens.

What could cause this?
S3D-Jason
Posts: 1383
Joined: Sun May 31, 2015 6:01 am

Re: CR-10 Z+ & Z- both move downward

The limit switch should definitely stop the motion if your firmware is setup correctly. Have you by change installed new firmware on this printer or replaced the electronics board recently?

Return to “Troubleshooting and Bug Reports”