Page 1 of 1
[ADDED] Minimize Perimeter Crossing
Posted: Sat Dec 06, 2014 9:56 pm
by Daedalus1400
This feature would make moves stay inside the perimeter of the object if possible. This helps to reduce the visible stringing, since the nozzle doesn't go "outside" the object unless absolutely necessary.
This has already been implemented in Slic3r and Cura, and is very useful for producing near-flawless print surfaces with ooze-prone nozzles and/or filament.
Thanks.
Re: Feature Request: Minimize Perimeter Crossing
Posted: Tue Dec 09, 2014 11:28 pm
by jd_3d
I second this request. It would be extremely useful for me!
Re: Feature Request: Minimize Perimeter Crossing
Posted: Wed Dec 10, 2014 5:04 am
by laird
+1.
Re: Feature Request: Minimize Perimeter Crossing
Posted: Wed Dec 10, 2014 7:06 am
by Edwin
+1.
Re: Feature Request: Minimize Perimeter Crossing
Posted: Mon Dec 15, 2014 3:47 pm
by rsn88
+1 . It would be extremely useful for me too !!!
Re: Feature Request: Minimize Perimeter Crossing
Posted: Tue Jan 27, 2015 12:55 pm
by frank26080115
My current project involves a large printed part that must fit inside another large printed part with a cavity. Any dripping would ruin the fit. I am forced to use Cura to slice this project because S3D doesn't have this feature
This is known as "combing" (putting the word here so it can be searched for)
Re: Feature Request: Minimize Perimeter Crossing
Posted: Thu Jul 09, 2015 8:33 pm
by S3D-Jason
This feature was added in Simplify3D version 3.0.0. Go the to Advanced tab and enable "avoid crossing outlines for travel movements"