Dense suppot extra expansion doesnt do anything.

[RetroDesign3D]

I thought this would make the dense support wider than the support structure below it.. but no matter what setting I add .. there seems to be no change at all ?

[S3D-Jason]

It expands the dense support, but only up until the boundary where the normal supports were already defined.

If you want to expand all of the support regions, use the Support Inflation Distance setting.

[RetroDesign3D]

Thanks.. my mistake then. would be nice though if the dense could overhang the primary a little. so we don't have to hug an entire vertical wall more closely for a closer top fit.