How to fix not filled in region
Posted: Sat Mar 04, 2023 2:06 am
Simplify3D User Forum
Simplifying the 3D Experience!
https://forum.simplify3d.com/
How to fix not filled in region
Page 1 of 1
Re: How to fix not filled in region
Posted: Mon Mar 06, 2023 12:07 pm
I'm guessing you just need to adjust the thin wall settings. There's a full article about it here:
https://www.simplify3d.com/resources/ar ... -features/
But I suspect the main change you need is Edit Process Settings > Advanced tab, and change the Internal Thin Wall Type to "Allow single extrusions".
https://www.simplify3d.com/resources/ar ... -features/
But I suspect the main change you need is Edit Process Settings > Advanced tab, and change the Internal Thin Wall Type to "Allow single extrusions".