bolsoncerrado
Posts: 177
Joined: Tue Mar 17, 2015 10:55 am

v5.0.2 Amazing ON-Air supports!

First we had Holidays On Ice.

Now we have Supports On Air!

LOL


Captura de pantalla 2023-03-15 a las 9.30.55.png
Captura de pantalla 2023-03-15 a las 9.32.27.png
GuyGuy
Posts: 19
Joined: Mon Jan 27, 2020 5:51 am

Re: v5.0.2 Amazing ON-Air supports!

+1
jfkansas
Posts: 133
Joined: Wed Oct 01, 2014 2:12 am

Re: v5.0.2 Amazing ON-Air supports!

It has to do with your support horizontal offset. Probably don't even need supports in that notch. If the corners of that notch don't need to be square, can add a fillet radius which would further lessen the need for supports.
bolsoncerrado wrote: Wed Mar 15, 2023 4:33 am First we had Holidays On Ice.

Now we have Supports On Air!

LOL



Captura de pantalla 2023-03-15 a las 9.30.55.png

Captura de pantalla 2023-03-15 a las 9.32.27.png
bolsoncerrado
Posts: 177
Joined: Tue Mar 17, 2015 10:55 am

Re: v5.0.2 Amazing ON-Air supports!

Never had these issues on v4....
arhi
Posts: 483
Joined: Thu Oct 06, 2016 5:13 pm

Re: v5.0.2 Amazing ON-Air supports!

bolsoncerrado wrote: Sun Mar 19, 2023 6:48 am Never had these issues on v4....
4.x was behaving similarly with this type of parts so same "in the air" support happened in 4.x too ... and similar issues with similar geometry happen with other slicers too .. new tree supports are the only that I have not seen this yet (YET!! maybe there are geometries that will fail them too we'll see, new tree supports are too new to be sure about anything)
gcodestat integrates with Simplify3D and allow you to
Calculate print time accurately (acceleration, max speed, junction deviation all taken into consideration)
Embed M117 codes into G-Code
Upload your G-Code directly to Octoprint
open source and unlicence

Return to “Troubleshooting and Bug Reports”