Page 1 of 1
v5.0.2 Amazing ON-Air supports!
Posted: Wed Mar 15, 2023 4:33 am
by bolsoncerrado
First we had Holidays On Ice.
Now we have Supports On Air!
LOL
Re: v5.0.2 Amazing ON-Air supports!
Posted: Wed Mar 15, 2023 8:48 am
by GuyGuy
+1
Re: v5.0.2 Amazing ON-Air supports!
Posted: Thu Mar 16, 2023 5:36 pm
by jfkansas
It has to do with your support horizontal offset. Probably don't even need supports in that notch. If the corners of that notch don't need to be square, can add a fillet radius which would further lessen the need for supports.
bolsoncerrado wrote: ↑Wed Mar 15, 2023 4:33 am
First we had Holidays On Ice.
Now we have Supports On Air!
LOL
Captura de pantalla 2023-03-15 a las 9.30.55.png
Captura de pantalla 2023-03-15 a las 9.32.27.png
Re: v5.0.2 Amazing ON-Air supports!
Posted: Sun Mar 19, 2023 6:48 am
by bolsoncerrado
Never had these issues on v4....
Re: v5.0.2 Amazing ON-Air supports!
Posted: Sun Mar 19, 2023 8:45 am
by arhi
bolsoncerrado wrote: ↑Sun Mar 19, 2023 6:48 am
Never had these issues on v4....
4.x was behaving similarly with this type of parts so same "in the air" support happened in 4.x too ... and similar issues with similar geometry happen with other slicers too .. new tree supports are the only that I have not seen this yet (YET!! maybe there are geometries that will fail them too we'll see, new tree supports are too new to be sure about anything)