Simplify3D User Forum • [FIXED] V5.1 / Print infill before perimeters

Page 1 of 1

[FIXED] V5.1 / Print infill before perimeters

Posted: Fri May 12, 2023 1:59 pm

by Christian_SnapMaker

If I use the option "Print infill before perimeters" in V5.1 no perimeters will be generated.

Without the option "Print infill before perimeters":

With option "Print infill before perimeters" enabled:

Re: V5.1 / Print infill before perimeters

Posted: Tue Jun 06, 2023 8:06 am

by S3D-Jason

This issue was fixed in our latest V5.1.1 release. You can view other changes in that version at the link below:
https://www.simplify3d.com/products/sim ... ase-notes/

Thank you for reporting the issue!