MacroscopicSolutions
Posts: 1
Joined: Wed May 17, 2023 10:27 am

Support Base Layer Pulls my Printer out of Duplication Mode

Duplication mode works perfectly well on my Makergear M3; however, whenever I add a value above 0, the Code stops my printer from printing in duplication mode. The T0 nozzle stays where it is, the T1 centers to the bed (runs into the T0 nozzle), strips itself on the belt and then starts printing between the 2 base layers of the actual part. Please fix!

Return to “Troubleshooting and Bug Reports”