[Craftbot Flow IDEX] Fan speed (M106) Using "P" Not "T"

[JonS]

I'm using 5.1 with my Craftbot Flow IDEX. It's generating M106 fan speed codes with "P" to index the tool, while the Craftbot using "T" (T0/T1).

How can I resolve this? Can the post processing scripts be used to replace strings?

p.s. I didn't have this issue when I was using 4.1

[S3D-Jason]

There's already a few threads about this on the forum if you search for it. Here's one that had a post-processing command you could use:
viewtopic.php?p=63519#p63519

[JonS]

There's already a few threads about this on the forum if you search for it. Here's one that had a post-processing command you could use:
viewtopic.php?p=63519#p63519

Thank you for the reply and pointer. My attempt at a search was a failure, so I'm not sure I would have found this.