Important settings options, very important
Posted: Tue May 23, 2023 12:36 pm
Hello!
Simplify3d is a good program!
BUT: It lacks things that I expect when I spend 200€, otherwise I can get into other slicers!
1. possibility of reducing the first or optionally the layers after infill. THIS IS VERY IMPORTANT!!!!
2. tree support to prevent unnecessary consumption of filament!!!
3. gcode display when going to print!!!
Would be nice if you as developers program this time!
THANKS
Simplify3d is a good program!
BUT: It lacks things that I expect when I spend 200€, otherwise I can get into other slicers!
1. possibility of reducing the first or optionally the layers after infill. THIS IS VERY IMPORTANT!!!!
2. tree support to prevent unnecessary consumption of filament!!!
3. gcode display when going to print!!!
Would be nice if you as developers program this time!
THANKS