Better seam positioning
Posted: Tue Jun 06, 2023 5:27 pm
by jwhils
I'm still not happy with how S3D handles seams and positioning for retractions. Can we get something similar to the ALIGNED seam feature in Prusaslicer (and forks) and Cura. I often print geometric and curved parts, and getting the seams aligned to sharp corners or areas that make sense is a time-consuming nightmare in S3D. I'm using other slicers for these parts and S3D for purely structural components that aren't seen.
Re: Better seam positioning
Posted: Thu Jun 08, 2023 7:52 am
by 3dbybrunolopes
jwhils wrote: ↑Tue Jun 06, 2023 5:27 pm
I'm still not happy with how S3D handles seams and positioning for retractions. Can we get something similar to the ALIGNED seam feature in Prusaslicer (and forks) and Cura. I often print geometric and curved parts, and getting the seams aligned to sharp corners or areas that make sense is a time-consuming nightmare in S3D. I'm using other slicers for these parts and S3D for purely structural components that aren't seen.
Already adress this, no reply from them
viewtopic.php?t=17243