Page 1 of 1
first layer width no effect
Posted: Fri Dec 12, 2014 12:22 am
by jack_n
Hello,
Changing the first layer width has no effect.
I Tried 100% 125% 150% the part always looks the same on the bottom face.
Re: first layer width no effect
Posted: Fri Dec 12, 2014 8:02 am
by jimc
It definately has an effect. I have tried it as well ad it does work. You should be able to see a difference in you gcode preview. Remember that the actual width is determined by you z height calibration on your machine. The tighter the gap the wider the width.
Re: first layer width no effect
Posted: Sat Dec 13, 2014 1:30 pm
by jack_n
Hello,
yes-you are wright.
I did not see this on the part, but in the preview.
Thank you
Joachim