Flashforge dual No end stop
Posted: Mon Dec 15, 2014 8:13 am
Hi all
When I start up with a new project and printer start up, it runs over in the opposite corner, but it tries to run farther one printer is wide.
I can not find any settings that make that I can change it.
Is there anyone who can help me?
Br,
Regards
Skovborg
When I start up with a new project and printer start up, it runs over in the opposite corner, but it tries to run farther one printer is wide.
I can not find any settings that make that I can change it.
Is there anyone who can help me?
Br,
Regards
Skovborg