Simplify3D User Forum

Posted: **Fri May 24, 2013 5:16 am**

Hi all, my first post here.

I have a delta style printer and being a bit of a novice I was hoping someone could share a configuration file for a delta printer, just to get me started.

Thankyou

Regards
Jamie

Posted: **Fri May 24, 2013 4:54 pm**

I am in the same boat as you.

What firmware are you running?

Can you see temps in the machine control window, other than the log box showing them?

Posted: **Fri May 24, 2013 8:06 pm**

I'm using repetier, which I know isn't supported. But I just want to save to SD and print from there.

Just need a few numbers to start with. What I tried didn't work and the printer just paused about 4 seconds into the print. Obviously I'm doing something wrong...

Simplify3D User Forum

Delta / rostock setup starting point ?

Delta / rostock setup starting point ?

Re: Delta / rostock setup starting point ?

Re: Delta / rostock setup starting point ?