Center print on Mendel Max 1.5
Posted: Thu Jan 01, 2015 3:29 pm
Hello,
I have been trying to figure out how to center prints with S3D on my mendelmax 1.5. My heated bed is just the prusa 200x214mm bed so its a little smaller then the MM 1.5. I have been playing with the offset settings but they are not taking. Is there a way to center the print?
Thank you,
Cameron
I have been trying to figure out how to center prints with S3D on my mendelmax 1.5. My heated bed is just the prusa 200x214mm bed so its a little smaller then the MM 1.5. I have been playing with the offset settings but they are not taking. Is there a way to center the print?
Thank you,
Cameron