Simplify3D User Forum

Posted: **Sat Jan 03, 2015 11:57 am**

This request is to add a feature when moving parts around on the mac version that the camera does not switch to the overhead view.

This makes moving pieces that are underneath other pieces difficult.

Drew

Posted: **Thu Jan 08, 2015 4:41 am**

Posted: **Thu Jan 08, 2015 12:16 pm**

Posted: **Thu Jul 09, 2015 1:10 pm**

This feature has been added in version 3.0

Simplify3D User Forum

[ADDED] Move parts in any view position

[ADDED] Move parts in any view position

Re: Move parts in any view position

Re: Move parts in any view position

Re: Move parts in any view position