Page 1 of 1
Scaling, Feature or Bug?
Posted: Sun Jan 04, 2015 7:40 pm
by jfkansas
So I scaled an object to .95 setting and all was ok. I previewed and output a .x3g file.
Closed the program, reopened, then the scaling was 1.00 again. However the part was smaller like I scaled it previously.
Re: Scaling, Feature or Bug?
Posted: Mon Jan 05, 2015 8:27 pm
by AK_Eric
This feels like a bug to me, I've experienced the same thing: The scale value should stay as set by the user, rather than "resetting":
If I bring in multiple parts and scale them all differently, upon reopening the tool I'd expect those scale values to be preserved.
2c
Re: Scaling, Feature or Bug?
Posted: Tue Jan 06, 2015 5:47 pm
by reddadsteve
I posted this exact same question a while back and the answer I received from S3D was that this is a 'feature' and not a bug.
With all the other wonderful features in S3D I also find this quite odd myself.
Steve
Re: Scaling, Feature or Bug?
Posted: Wed Jan 07, 2015 2:42 pm
by kyphur
Posted this also a while back. This "feature" just cost me about 20+ bucks of wrong sized prints that are supposed to fit together.