Page 1 of 1
Interface layer settings for infill
Posted: Tue Feb 03, 2015 12:08 pm
by McSquid
The new interface layer settings for support material is great! This would be a great feature to add to infill as well. No changes would be needed that I can think of.
Re: Interface layer settings for infill
Posted: Wed Feb 04, 2015 5:16 am
by JoeJ
They already have solid infill and sparse infill. Similar to how they have the dense support and sparse support. Both of them already allow you to set the number of solid/dense layers.
Re: Interface layer settings for infill
Posted: Wed Feb 04, 2015 4:19 pm
by BaronWilliams
I agree. This will be useful to have for infill as well!