Wifi
Posted: Mon Mar 09, 2015 4:17 pm
The Flashforge Dreamer allows print by wifi, which was the only nice thing about whatever software was their default. Any chance of a future upgrade allowing that?
Page 1 of 1
Re: Wifi
Posted: Wed Mar 18, 2015 7:56 pm
Wifi compatibility would be nice. However I ALWAYS watch my first few layers get printed, so I may as well bring my SD card over t the party anyways.
Re: Wifi
Posted: Thu Mar 19, 2015 5:45 am
Very valid point, I agree!DarthRevan wrote:Wifi compatibility would be nice. However I ALWAYS watch my first few layers get printed, so I may as well bring my SD card over t the party anyways.