Mini Kossel
Posted: Tue Mar 10, 2015 4:04 pm
Hi, has any of you tried S3D on Mini Kossel printer? I had a lot of trouble with the original software for Commissioning and Calibration. Does use S3D will make thing a lot easier?
Page 1 of 1
Re: Mini Kossel
Posted: Wed Mar 11, 2015 8:24 am
They already include a pre-configured profile in S3D for the Kossel Mini, so it's really easy to setup. But more important that the easy setup is all the extra control and features you get from using the software
Re: Mini Kossel
Posted: Sun Mar 22, 2015 1:05 pm
I wholeheartedly agree on this. Simplify3D does a beautiful job on my Kossel XXL (1000mm high frame) with an E3D-V6 3mm bowden hot-end!