Support for Ender 3 V3 KE
Posted: Fri Dec 29, 2023 10:04 am
Bought the Ender 3 V3 KE and an S3D licence today.
Before purchase I used the dialog in https://www.simplify3d.com/products/sim ... atibility/
where it (and its little brother SE) is shown as supported.
Downloaded 5.1.2 and installed on my Linux machine.
When trying to add a new printer profile in the configuration assistant, no Ender 3 V3 models show up.
What am I doing wrong?
Before purchase I used the dialog in https://www.simplify3d.com/products/sim ... atibility/
where it (and its little brother SE) is shown as supported.
Downloaded 5.1.2 and installed on my Linux machine.
When trying to add a new printer profile in the configuration assistant, no Ender 3 V3 models show up.
What am I doing wrong?