Simplify3D User Forum

Hi everyone,

I'm a new user of Simplify 3D. Up til now I've been using Flashforge's slicer Flashprint with my Flashforge Guider 2S. My question relates to managing the files stored in my printer's memory via Simplify3D's Machine Control Panel under the Device Files. When the printer is connected (wi-fi) and idle I can see the files listed but I cannot do anything with them. Am I missing a step?

You use the buttons below the device files list to print or delete files on the storage drive. I've used those options with several of our FlashForge printers without any issues. If you're having issues, I would recommend checking the Communication tab for any errors. You could also paste that full log in this thread if you think it would help to show the issue (just make sure to identify where in the log you were actually pushing certain buttons).