Simplify3D User Forum

I am working with a Markforged Mark Two. It doesn't come up in the compatibility list. Their website says the firmware is called Flounder, and that it uses components of Marlin.

Anybody use one of these, get it working, have any success?

Thanks!

S3D is already compatible with machines running Marlin, so if Flounder is just a fork of Marlin then there's a good chance it would be compatible. Do you have a gcode file you can attach that you have already successfully printed on the Mark Two?

mortal798 wrote: ↑Thu Feb 15, 2024 6:43 pm I am working with a Markforged Mark Two.

Those use some really specialized pathing to optimize the continuous fiber filaments. Best of luck with that.