Page 1 of 1
Crash on open due to corrupted saved state
Posted: Tue May 21, 2024 8:08 pm
by Mitchell_VonB
If the saved state of simplify (found in C:\Users\your username here\AppData\Local\Simplify3D\S3D-Software-V5) is corrupted, which it has a coin's flip chance of being after a crash, simplify will instantly crash on startup. The only solution to fix this is to navigate to the file and delete it. A simple integrity check of the saved state file before simplify attempts to open it would fix this.
Re: Crash on open due to corrupted saved state
Posted: Wed May 22, 2024 12:51 pm
by S3D-Jason
Hmm... I've never seen this happen on my computer. Can you attach one of the "corrupted" files that wouldn't open? Are you sure it isn't some kind of permissions issue instead?
Re: Crash on open due to corrupted saved state
Posted: Wed May 22, 2024 7:44 pm
by Mitchell_VonB
Next time it happens I'll grab the file and upload it here.
Re: Crash on open due to corrupted saved state
Posted: Mon Feb 10, 2025 5:32 pm
by Mitchell_VonB
Finally had this bug happen again and grabbed the corrupted save state file. How do I get a file over 3mb uploaded properly on this forum?
Re: Crash on open due to corrupted saved state
Posted: Tue Feb 11, 2025 1:25 pm
by S3D-Jason
You can always email it directly to our team at the link below:
https://www.simplify3d.com/contact-us/
Re: Crash on open due to corrupted saved state
Posted: Wed Feb 12, 2025 1:26 pm
by Mitchell_VonB
Sent