alexmartire
Posts: 1
Joined: Fri May 31, 2024 11:48 am

Auto low bed after printing

Hello, I am printing on K1 Max and, upon finishing the printing, the print bed does not automatically lower, causing the nozzle to remain leaning against the print and thus damaging it. Is there any option or code I have to add to avoid this? Thanks in advance!
S3D-Jason
Posts: 1446
Joined: Sun May 31, 2015 6:01 am

Re: Auto low bed after printing

You could probably add a single G1 Zxxx F1800 command in your ending script. Replace "xxx" with the Z height of the machine. That will move it to the top when the print is done.

Return to “General Discussion and Tips”