Simplify3D User Forum

I have recently purchased a new SV06 Plus, in addition to my modified Wanhao Di3v1. Simplify 4.xx was always working well on that old wanhao. I tried using the cura slicer that came with the sovol printer, and also prusa slicer, which has a profile for that printer....I could not figure them out.... the first layers always looked awfull. Now I upgraded to S3DV5 because it claimed to have a profile for the SV06Plus. And there you go - adjusted some settings (infill, no.of perimeters etc) and the new SV06 prints like a charm. First try, forst layer, a dream.

So thank you from my side to the S3d Team for the continous work and effort.

Regards,

Basti

That's great to hear about your results! I know the team spends quite a bit of time with each new machine to make sure our stock settings produce good results, so I'm glad their work is paying off.