Feature request: number of perimeters on top/bottom surface
Posted: Wed Jul 10, 2024 11:16 pm
Hi all. I just bought Simplify 3D. I have tested almost every slicer there is out there and after looking through the settings available in S3D I think it looks pretty good. There are many things I like about it. However There is 1 setting that I was dissapointed in not seing. That is number of perimeters in top and bottom surfaces. This makes printed parts look a lot better imo. Maybe I'm wrong but I assume that most users would prefer this over ironing so I was very surprised to see ironing was added before control over perimeters in top/bottom surfaces.
Splitting my models top and bottom surfaces in order to assign an extra procces for this takes forever
I hope to se this setting added in the future. It would make me very happy!
Splitting my models top and bottom surfaces in order to assign an extra procces for this takes forever
I hope to se this setting added in the future. It would make me very happy!