Lw-Pla
Posted: Sun Jul 14, 2024 3:34 pm
by chrispol
Does anyone have a good profile for lw-pla? I am having issues with the top layer when using a 5% gyroid infill, that I do not experiance in orca slicer.
Re: Lw-Pla
Posted: Mon Jul 22, 2024 12:44 pm
by S3D-Jason
I don't have too much experience with lightweight PLA, but I will say that the new Dense Infill feature in V5.1 can be a big help for improving your top layers with only a small amount of extra material. It starts increasing the infill density just below the top layers and made a big difference in many of my prints!