BLD0550
Posts: 1
Joined: Mon Jul 15, 2024 12:31 am

Infill small area

Been using Simplify3d for years. Never printed anything with this small of detail before.
Is there a setting that would fill these small teeth as shown in the image. teethe are 1mm wide 2mm oc for a 2GT belt
Attachments
Screenshot 2024-07-14 231905.jpg
S3D-Jason
Posts: 1498
Joined: Sun May 31, 2015 6:01 am

Re: Infill small area

There's far more info than what I could describe at the link below, so I would definitely review that first:
https://www.simplify3d.com/resources/ar ... -features/

Just guessing from the photo, but you probably also need to increase the "allowed perimeter overlap" setting to get those very small regions to be filled. I think the default is 10%, but something like 30% might work better for that exact print.

Return to “General Discussion and Tips”