Been using Simplify3d for years. Never printed anything with this small of detail before.
Is there a setting that would fill these small teeth as shown in the image. teethe are 1mm wide 2mm oc for a 2GT belt
Infill small area
- Attachments
-
Re: Infill small area
There's far more info than what I could describe at the link below, so I would definitely review that first:
https://www.simplify3d.com/resources/ar ... -features/
Just guessing from the photo, but you probably also need to increase the "allowed perimeter overlap" setting to get those very small regions to be filled. I think the default is 10%, but something like 30% might work better for that exact print.
https://www.simplify3d.com/resources/ar ... -features/
Just guessing from the photo, but you probably also need to increase the "allowed perimeter overlap" setting to get those very small regions to be filled. I think the default is 10%, but something like 30% might work better for that exact print.
