tblake@ontoto.com
Posts: 1
Joined: Sun Aug 25, 2024 8:41 pm

guider 3 "model too large" error

Hello, I am using the wizard to set up for my Guider 3. however I keep getting the error " model too large" from the printer.
Can anyone assist?
S3D-Jason
Posts: 1495
Joined: Sun May 31, 2015 6:01 am

Re: guider 3 "model too large" error

Are there any commands in the starting or ending scripts that use very large X/Y/Z values? For example, G1 Z300 if the machine only has a 200mm Z size. I think that could sometimes trigger errors like this.

Another idea could be if you have any parts that are outside of the printable area. For example, a part that is too close to the end, or a very large skirt that ends up going out-of-bounds.

Return to “Troubleshooting and Bug Reports”