Hello, I am using the wizard to set up for my Guider 3. however I keep getting the error " model too large" from the printer.
Can anyone assist?
-
tblake@ontoto.com
- Posts: 1
- Joined: Sun Aug 25, 2024 8:41 pm
Re: guider 3 "model too large" error
Are there any commands in the starting or ending scripts that use very large X/Y/Z values? For example, G1 Z300 if the machine only has a 200mm Z size. I think that could sometimes trigger errors like this.
Another idea could be if you have any parts that are outside of the printable area. For example, a part that is too close to the end, or a very large skirt that ends up going out-of-bounds.
Another idea could be if you have any parts that are outside of the printable area. For example, a part that is too close to the end, or a very large skirt that ends up going out-of-bounds.
