Elegoo OrangeStorm Giga support
Posted: Fri Oct 11, 2024 1:54 am
by jgwinner
I had to move FURNITURE to get this thing up.
It's glorious.
Cura is OK, but I would love to see Simplify3D support!
Has anyone tried it?
== John ==
Re: Elegoo OrangeStorm Giga support
Posted: Mon Oct 14, 2024 9:48 am
by S3D-Jason
Most of the Elegoo firmwares accept standard Marlin/Klipper style gcode commands, so there's a good chance it's already compatible without any other changes. You could try going to Help > Configuration Assistant, and then choose the option at the bottom to manually enter the printer specs. That will setup a profile for those exact specs and then you can customize the starting/ending scripts based on your preference.