One of the settings must be triggering the slicer to fill the model but I can't figure it out. infill is 0 solid is 0 no top or bottom layers. just 2 perms. (same problem with 1 perm)
Ideas? factory file attached
Why is it filling the model? should be hollow!
- Attachments
-
- Falcon_Heavy_Earring(2).factory
- (411.25 KiB) Downloaded 552 times
-
S3D-Taylor
- Posts: 101
- Joined: Tue Jun 20, 2023 10:55 am
Re: Why is it filling the model? should be hollow!
Reducing the value for Solid Infill Threshold Area should solve the problem. This is usually used to strengthen weaker regions.
