Simplify3D User Forum

Hello.
when I run this spring slicer S3D 4.0, plastic is missing at both ends.

and in 5.0 plastic is missing at one end...?!

What could this be due to?
I have test to change width 40-48 (0,4 nozzle)

PS: No other printers on Thingverse have this problem with others slicers

Se 3st pic

There could be some mesh issues in this model. You can try the different Slicing Region Repair Mode explained here: https://www.simplify3d.com/resources/ar ... sh-errors/