DLP 3D Printer support

[MasterCATZ]

I am about to order this
http://www.gizmo3dprinters.com.au

it prints 20mm per 5 minutes,
super fast printing one layer takes around 80 milliseconds
the base is up to 405mm x 262mm


and wondering if simplify3d would dip their fingers into DLP 3d printing resin

it just needs to display a layer for x amount of time undisplay move axis redisplay new image rinse repeat


hopefully I am not posting any confidential information but I have been chatting with the creator for a while now

"what controller / stepping motor ect is being used"
Sanguinololu 1.3a with three DRV8825 steppers
Nema 23 for the 20mm Z axis ballscrew

[rsilvers]

My advice is to not order a printer that the website selling it only has computer graphics showing the product.