Simplify3D User Forum

Trying to dial in bridging on my Ender 3 with Simplify3D. Using PLA, 200°C, but bridges are sagging. Should I lower speed or increase cooling?

This should help: https://www.simplify3d.com/resources/pr ... -bridging/

WonderNomad wrote: ↑Wed Apr 16, 2025 11:16 pm Trying to dial in bridging on my Ender 3 with Simplify3D. Using PLA, 200°C, but bridges are sagging. Should I lower speed or increase cooling?

I've had similar issues! Increasing the cooling usually makes a big difference for bridges. Maybe try lowering the temp a bit too if it's still sagging.