Top geometry cutting into bottom layer
Posted: Wed Apr 30, 2025 2:57 am
by ACertainReality
I want to print a single layer thin sheet with some geometry on top, But instead of it printing a continuous initial layer it cuts it where the geometry lays on top, Any help would be appreciated.
Re: Top geometry cutting into bottom layer
Posted: Wed Apr 30, 2025 10:30 am
by S3D-Taylor
Increasing the value of
Top Layer Extra Expansion should solve this. The post here explains a bit further:
viewtopic.php?p=74471#p74471
Re: Top geometry cutting into bottom layer
Posted: Wed Apr 30, 2025 11:34 pm
by ACertainReality