Simplify3D User Forum

When editing the settings -- on the "Other" tab -- various speeds can be set.

However, I cannot increase many of the speeds above 100 percent. Namely...

Outline Underspeed

Solid Infill Underspeed

Support Structure Underspeed


I want to increase the support structure speed to 110% but I cannot. 100% is the limit. Why?

A user should be able to speed up and slow down every type of operation (outline, infill, support structure, whatever! etc.).
This would give maximum versatility in creating fast, quality prints.

I tried a workaround of boosting the default print speed, then adjusting the underspeeds. This does not work as it throws off other portions of critical print speeds.

Ken Huebner
Product Developer

+1
i think can be 500% for some prints

Example:
material: flex
regular speed: 30 mm/s
support speed can be: 50-90 mm/s (~160..300% from regular)

But you're using absolute speeds (e.g., 30 mm/sec). Seems to me the percentage approach (e.g., 110%) should be supported as well, since it's more versatile.

+1

This has been changed in version 3.0. You can now enter values greater than 100% for those options if you choose.