Crash after picking prepare to print
Posted: Sat May 09, 2015 3:33 pm
by nxumdon
Running the latest version, after importing a model and picking prepare to print, the program just closes/crashes...it was working fine yesterday :/
Re: Crash after picking prepare to print
Posted: Sun May 10, 2015 6:41 am
by JoeJ
I'm guessing it's a graphics issue. Maybe try going to Tools --> options, click the Visualization tab, and set to "Low Detail" preview mode. Also enable the "use legacy graphics" option. Does that help? If not, I would post the factory file so someone else can test to see if it is only specific to your computer/drivers.