Are there any configs for this printer
I bought the software several months back for the all to well known "Peelable supports"
I have yet to get more than 3 good prints from it
take the same stl file and run it in mattercontrol and its perfect
I know its in the settings but havent been able to lock it down
basically I can start a print and maybe I get one decent or ok print but 2 is unhead of.
Seems like the hotend is jamming but again it doesnt when I close Simplify and load mattercontrol
i've adjusted the retract as well as turn it off all together
any help would be appreciated it