Simplify3D User Forum

Any Creatbot users using simplify 3d?

any hints and tips that you can share for using the printer with simplify3d?

I've talked to quite a few people who use that printer with S3D. If you're looking for help with your first profile, you might want to email their support team, cause they may already have a pre-configured profile for it.

no joy with the default settings, having to use the creatbot slicer till i figure it out

paeonius wrote:no joy with the default settings, having to use the creatbot slicer till i figure it out

What issues are you experiencing?

the machine is printing very very slowly using creatbot software
but when I try simplify3d the top layers arent forming properly so im trying with more top and bottom layers
the other issue is when i use s3d the head would stop randomly during the prints
i would assume the bowden head would allow me to print much faster than the replicator2

here is my current process
https://www.dropbox.com/s/gf37urizbhwaz ... 1.fff?dl=0

hi
im intressted in buy one creatbot dx plus.
can you recommend it?

thanks,

andy

logic1208 wrote:hi
im intressted in buy one creatbot dx plus.
can you recommend it?

thanks,

andy

Pro
they are cheap

Con
support is not good

they use a bowden head so you might have to change back to 3mm instead of 1.75mm filament

i have had heaps of problems with the 4 machines I use

thanks!

did you end up sorting this out

kind of gave up on the machines, still have them but dont use them much