Ok I have a Makergear M2 with dual Extruders. I followed along with Simplify3d's traffic cone example step by step. It says to save it to a memory card but when I do that I get this Message: There is no application set to open the document "Traffic_Cone_Rings_White-2.gcode".
What do I need to open this?
Thanks
Re: Software trouble
Well why are you trying to open the .gcode file? You just need to copy it to the SD card, not open it.
And for reference, gcode files are just text files, so you can open them with any text editor you have like notepad, etc.
And for reference, gcode files are just text files, so you can open them with any text editor you have like notepad, etc.
